Advanced Features
English
36
Finding and Connecting to a Bluetooth Device
Procedure:
1 Turn on your Bluetooth-enabled device and place it in
pairing mode. Refer to respective Bluetooth-enabled
device’s user manual.
2 On your radio, press the programmed Bluetooth Connect
button.
3 A tone sounds and LED blinks yellow.
4 Your Bluetooth-enabled device may require additional steps
to complete the pairing. Refer to respective Bluetooth-
enabled device’s user manual.
5 If successful, a positive tone sounds.
OR
If unsuccessful, a negative indicator tone sounds.
Do not turn off your Bluetooth-enabled device during the finding
and connecting operation as this cancels the operation.
Your radio connects to the Bluetooth-enabled device within
range with either the strongest signal strength, or to one which it
has connected to before in a prior session.
NOTE: A pin code may be required to be programmed in your
radio before it can pair with some devices. Contact
your dealer for more information.
Disconnecting from a Bluetooth Device
Procedure:
1 Press the programmed Bluetooth Disconnect button.
2 A positive indicator tone sounds when disconnected.
Switching Audio Route
You can toggle audio routing between internal radio speaker
and external Bluetooth-enabled accessory.
Procedure:
1 Press the programmed Bluetooth Audio Switch button.
2 A tone sounds when the audio route has switched.
NKP_EMEA.book Page 36 Monday, July 30, 2012 9:01 AM
To Next Page
Loading...