Receiving and Making Calls
English
21
Making an All Call
This feature allows you to transmit to all users on the channel.
Your radio must be programmed to allow you to use this feature.
Procedure:
1 Select the channel with the active group alias or ID. See
Selecting a Channel on page 14.
2 Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm) from
your mouth.
3 Press the PTT button to make the call. The LED lights up
solid green.
4 Wait for the Talk Permit Tone to finish (if enabled) and speak
clearly into the microphone.
OR
Wait for the PTT Sidetone to finish (if enabled) and
speak clearly into the microphone.
Users on the channel cannot respond to an All Call.
Making a Phone Call
NOTE: When you attempt to make or end a Phone Call without
the access and deaccess codes preconfigured, the
attempt fails and a negative indicator tone sounds.
Procedure:
1 Press the programmed One Touch Access button to make
a Phone Call to the predefined ID.
If the entry for the One Touch Access button is empty, a
negative indicator tone sounds.
2 If successful:
The DTMF tone sounds. You hear the dialing tone of the
telephone user.
OR
If unsuccessful:
A negative indicator tone sounds and the Phone Call
attempt fails. Repeat Step 1.
3 Press the PTT button to talk and release it to listen.
4 Press the programmed Phone Exit button to end the call
and a DTMF tone sounds.
To Next Page
Loading...