Making and Receiving Calls
English
33
When you press PTT button while in the Phone Contacts
screen, a tone sounds and the display shows Press OK to
Place Call.
When the telephone user ends the call, a tone sounds and the
display shows Call Ended.
During channel access, press
d to dismiss the call attempt
and a tone sounds.
During the call, when you press One Touch Access button with
the deaccess code preconfigured or enter the deaccess code
as the input for extra digits, your radio attempts to end the call.
Stopping a Radio Call
This feature allows you to stop an ongoing Group or Private Call
to free the channel for transmission. For example, when a radio
experiences a “stuck microphone” condition where the PTT
button is inadvertently pressed by the user.
Your radio must be programmed to allow you to use this
feature.
Procedure:
While on the required channel:
1 Press the programmed Transmit Interrupt Remote Dekey
button.
2 The display shows Remote Dekey.
3 Wait for acknowledgment.
4 The radio sounds a positive indicator tone and the display
shows Remote Dekey Success, indicating that the channel
is now free.
OR
The radio sounds a negative indicator tone and the display
shows Remote Dekey Failed.
On the interrupted radio, the display shows
Call Interrupted
and your radio sounds a negative indicator tone until you
release the PTT button, if it is transmitting an interruptible call
that is stopped via this feature.
To Next Page
Loading...