Press the PTT button to talk and release it to
listen.
Inbound Phone Multi-Group Call
When you receive an Inbound Phone Multi-Group
Call, the Group Call icon appears in the top right
corner. The first text line shows Multigroup Call.
The radio unmutes and the incoming multi-group call
sounds through the radio's speaker.
Making a Radio Call
After selecting your channel, you can select a
subscriber alias or ID, or group alias or ID by using:
• The Channel Selector Knob.
• A programmed One Touch Access button – The
One Touch Access feature allows you to make a
Private Call to a predefined ID easily. This feature
can be assigned to a short or long programmable
button press. You can ONLY have one ID
assigned to a One Touch Access button. Your
radio can have multiple One Touch Access
buttons programmed.
• The Contacts list (see Contacts Settings on page
208).
• Manual Dial – This method is for Private Calls only
and is dialed using the keypad (see Making a
Private Call from Contacts on page 209, and
Making a Call with the Programmable Manual Dial
Button on page 192).
Note: Your radio must have the Privacy feature
enabled on the channel to send a privacy-enabled
transmission. Only target radios with the same Key
Value and Key ID as your radio will be able to
unscramble the transmission.
Note: See Privacy on page 240 for more information.
Making a Call with the Channel Selector Knob
Making a Group Call
To make a call to a group of users, your radio must
be configured as part of that group.
1 Select the channel with the active group alias or
ID. See Selecting a Call Type on page 185.
2 Hold the radio vertically 1 to 2 inches (2.5 to 5.0
cm) from your mouth.
3 Press the PTT button to make the call.
Making and Receiving Calls in Connect Plus Mode
189
English
To Next Page
Loading...