Starting and Stopping Scan
While scanning, the radio will only accept data (e.g.
text message, location, or PC data) if received on its
Selected Channel.
1 Use the Channel Selector Knob to select a
channel programmed with a scan list.
2
to access the menu.
3
or to Scan and press to select.
4
or to Scan State and press to
select.
5
or to required scan state and press
to select.
•
The display shows Scan On when Scan is
enabled. The LED blinks yellow and the scan
icon appears.
•
The display shows Scan Off if Scan is
disabled. The LED turns off and the scan icon
disappears.
Responding to a Transmission During a Scan
During scanning, your radio stops on a channel/group
where activity is detected. The radio stays on that
channel for a programmed time period known as
“hang time”.
1 Hold the radio vertically 1 to 2 inches (2.5 to 5.0
cm) from your mouth.
If the Channel Free Indication feature is
enabled, you hear a short alert tone the moment
the transmitting radio releases the PTT button,
indicating the channel is free for you to respond.
2 Press the PTT button during hang time.
The LED lights up solid green.
3 Wait for one of the following tones to finish (if
enabled), and speak clearly into the microphone.
• The Talk Permit Tone.
•
The PTT Sidetone.
4 Release the PTT button to listen.
Advanced Features in Non-Connect Plus Mode
74
English
To Next Page
Loading...