a blinking cursor. Key in the subscriber alias or
ID and press .
The display shows Text Message:
<Subscriber/Group Alias or ID>, confirming
your message is being sent.
If the message is sent successfully, a tone sounds
and the display shows positive mini notice.
If the message cannot be sent, a low tone sounds
and the display shows negative mini notice.
Editing a Text Message
Select Edit to edit the message before sending it.
Note: If a subject line is present (for messages
received from an e-mail application), you cannot edit
it.
1
or to Edit and press to select.
A blinking cursor appears.
2 Use the keypad to edit your message.
Press to move one space to the left. Press or
the
key to move one space to the right.
Press the
key to delete any unwanted
characters. Long press to change text entry
method.
3
Press once message is composed.
4 Depending on whether you want to send, save, re-
edit, or delete the newly composed message, do
one of the following.
•
or to Send, and press to send the
message.
•
or to Save, and press to save the
message to the Drafts folder.
•
to edit the message.
•
again to choose between deleting the
message or saving it to the Drafts folder.
5 If you are sending the message, select the
recipient by
•
or to the required alias or ID and press
to select.
Advanced Features in Non-Connect Plus Mode
101
English
To Next Page
Loading...