Contacts list, the radio returns to the screen you
were on prior to initiating the call.
2 Hold the radio vertically 1 to 2 inches (2.5 to 5.0
cm) from your mouth.
3 Press the PTT button to talk and release it to
listen.
To enter extra digits, if requested by the Phone
Call, enter the extra digits using the keypad and
press
to proceed.
The DTMF tone sounds with each keypad press,
and the radio returns to the previous screen.
4
Press
to end the call.
If de-access code was not preconfigured in the
Contacts list, the display shows De-Access
Code:. Press the One Touch Access button, if it
is programmed with the de-access code. If the
entry for the One Touch Access button is empty,
a negative indicator tone sounds.
The DTMF tone sounds with each keypad press,
and the display shows Ending Phone Call.
If the end-call-setup is successful, a tone sounds
and the display shows Call Ended.
If the end-call-setup is unsuccessful, your radio
returns to the Phone Call screen. Repeat Step 4 or
wait for the telephone user to end the call.
Note: When the telephone user ends the call, a
tone sounds and the display shows Call Ended.
If the call ends while you are entering the extra
digits requested by the Phone Call, your radio
returns to the screen you were on prior to initiating
the call.
During channel access, press
to dismiss the
call attempt. A tone sounds to indicate success.
During the call, if you press the One Touch
Access button with the deaccess code
preconfigured or enter the deaccess code as the
input for extra digits, your radio attempts to end
the call.
The access or deaccess code cannot be more
than 10 characters.
Making and Receiving Calls in Non-Connect Plus Mode
51
English
To Next Page
Loading...