Name: Motorola MVME5100
Brand: Motorola
Rating: 5 (1 reviews)

Other manuals for Motorola MVME5100

Manual127 pages

Questions and Answers:

M
Marilyn WolfeAug 2, 2025
Why does my Motorola Desktop have no display and nothing works?
- K
  Kristi McfarlandAug 2, 2025
  If nothing is working and there's no display on your Motorola Desktop terminal, it could be due to several reasons. First, check that the system is plugged in and the board is securely installed. Ensure all necessary cables are connected. If the LEDs are lit, the board might be in the wrong slot; the MVME5100 should be in the first (leftmost) slot, and the 'system controller' function should be enabled as per the instructions. Also, the 'system console' terminal may be configured incorrectly, so configure it according to the manual.
D
Debra PetersonAug 6, 2025
What to do if Motorola Desktop keyboard and mouse not working?
- L
  Larry MendezAug 7, 2025
  If your Motorola Desktop has a display but the keyboard or mouse aren't working, the problem could be with the connections. Recheck the keyboard and mouse connections, including power, and verify the correct configuration of the RS232 interface. Also, check the board jumpers according to the manual's instructions. You might have accidentally activated flow control by pressing a HOLD or PAUSE key, or by typing -S; if so, press the HOLD or PAUSE key again, or type -Q.
B
billy00Aug 11, 2025
How to fix Motorola Desktop when Debug prompt PPC6-Bug doesn't appear at powerup?
- F
  fpooleAug 11, 2025
  If the Debug prompt PPC6-Bug> doesn't appear when you power up your Motorola Desktop and the board doesn't autoboot, it could be due to missing Debugger Flash. To resolve this, disconnect all power from your system, then check that the proper debugger devices are installed. Reconnect the power, and restart the system using the ABT/RST switch (press and hold for 3-5 seconds). If the debug prompt appears, proceed to step IV or V as indicated; otherwise, go to step VI. The board may also need to be reset.
B
Brian BrownAug 15, 2025
Why Motorola Desktop doesn't autoboot when Debug prompt PPC6-Bug appears?
- J
  Jose NelsonAug 15, 2025
  If the Debug prompt PPC6-Bug> appears when you power up your Motorola Desktop, but the board doesn't autoboot, the initial debugger environment parameters may be set incorrectly. Start the onboard calendar clock and timer by typing: set mmddyyhhmm , replacing the characters with the month, day, year, hour, and minute. Be cautious, as the next step (env;d) will change some parameters that may affect your system’s operation.