16
essentials
is charging. The display shows
Charge Complete
when finished.
Tip:
Relax, you can’t overcharge your battery.
It will perform best after you fully charge and
discharge it a few times.
Note:
You can charge your battery
by connecting a cable from your
phone’s mini-USB port to a USB
port on a computer. Both your
phone and the computer must be turned on,
and your computer must have the correct
software drivers installed. Cables and
software drivers are available in
Motorola Original data kits, sold separately.
turn it on & off
Caution:
On power up, the phone may
prompt you to enter your SIM card PIN code
to unlock the SIM card. If you enter an
incorrect PIN code three times in a row, your
SIM card is disabled and your display shows
SIM Blocked
. Contact your service provider.
To turn on your phone,
press and hold
O
for a
few seconds or until the
display turns on. If
prompted, enter your
six-digit SIM card PIN
code and/or four-digit unlock code.
To turn off your phone, press and hold
O
for
two seconds.
make a call
Enter a phone number and press
N
to make
a call.
To “hang up,” close the flip or press
O
.
To Next Page
Loading...
