24
CLONING RADIOS
3. Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1.
Press and release SB1.
4. After cloning is completed, the Source radio will
sound either a ‘pass’ tone (cloning was
successful) or a ‘fail’ tone (cloning process has
failed). The ‘pass’ tone sounds like a good key
‘chirp’ whereas the ‘fail’ tone sounds similar to a
‘bonk’ tone. If the Source radio is a display
model, it will either show ‘Pass’ or ‘Fail’ on the
display (a tone will be heard within 5 seconds).
5. Once you have completed the cloning process,
turn the radios OFF and ON to exit the ‘cloning’
mode.
Note: If cloning fails please refer to “What to Do If
Cloning Fails” on page 26.
Further details on how to clone units are
explained in the instructions sheet provided
with the MUC.
See accessories details on “Chargers” on
page 44.
Notes:
• Paired target radios and source radios must
be of the same type in order for cloning to run
successfully.
• (*) MUC pockets numbers should be read
from left to right with the Motorola logo facing
front.
Cloning Radios Using the Radio to Radio
(R2R) Cloning Cable (Optional Accessory)
Operating Instructions
Source Radio: Radio to be cloned.
To Next Page
Loading...
Need help?
General
