5.1.4
Programming Auto-Scan
Prerequisites: Enter the Advanced Configuration Mode.
Procedure:
To enter Auto-Scan mode, short press the PTT button.
Auto-Scan has the two following values:
● Enabled
● Disabled
Postrequisites:
● To continue programming, press the PTT button.
● To save settings and enter the Idle Programming mode, press and hold the PTT button.
● To exit Idle Programming mode, press and hold the PTT button twice.
● To exit the programming mode without saving, turn off the radio.
5.1.5
Programming Active Channels
Prerequisites: Enter the Advanced Configuration Mode and select your desired channel.
Procedure:
1. To enter the Active Channel mode, short press the PTT button while in the Auto-Scan mode.
2. To change the number of channels, press the SB1 or SB2 buttons.
Postrequisites:
● To continue programming, press the PTT button.
● To save settings and enter the Idle Programming mode, press and hold the PTT button.
● To exit Idle Programming mode, press and hold the PTT button twice.
● To exit the programming mode without saving, turn off the radio.
5.1.6
Programming FAQs
The following table lists a series of frequently asked questions (FAQs) by users related to programming the
RM Series radios.
Table 12: Programming FAQs
Question Answer
I got distracted while programming and forgot
which feature I was programming. What should I
do?
Return to Idle Programming mode and start over.
You are not able to return to programming mode.
The radio does not provide the specific stage you
are at in the programming mode.
Perform the following actions:
68012009071-BD
Chapter 5: Radio Programming through CPS
26
To Next Page
Loading...
