7Getting started
Connecting the base
1. Plug the telephone line cord into the socket marked on the rear of the base.
2. Plug the power adaptor into the socket marked
on the rear of the base and plug the
other end into the mains power wall socket. Switch on the mains power.
Installing and charging the handset
1. Remove the battery cover from the back of the handset and insert the rechargeable
Ni-MH battery cells supplied. Please note the ’+’ and ’-’ markings inside the battery
compartment and insert in the correct direction.
Use your
ngernail to
unclip the
cover and lift
up.
Insert your
ngernail
here.
Lower the
cover and
clip into
place.
Position the
battery cover
as shown.
To close: To open:
1
2
To Next Page
Loading...
