8
Getting started
1. Plug the telephone line cord into the socket marked on the rear of the
base.
2. Plug the power adaptor into the socket marked
on the rear of the base
and plug the other end into the mains power wall socket. Switch on the
mains power.
Installing and charging the handset
1. Remove the battery cover from the back of the handset and insert the
rechargeable Ni-MH battery cells supplied. Please note the ’+’ and
’-’ markings inside the battery compartment and insert in the correct
direction.
2. Slide the battery cover back into place.
3. If you are charging the batteries for the rst time, place the handset on
the base to charge for at least 24 hours continuously.
4. When the handset is fully charged,
icon will appear steady on the
display. Plug the other end of the telephone line cord (make sure that one
end is already plugged into the base) into the telephone wall socket.
Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process
for all the handsets and chargers.
Press
down
1
Slide
2
To Next Page
Loading...
Need help?
General
