Quick Reference Guide 9
Using a Host Interface to Supply Power
Some hosts can provide power to the cradle via the host interface, instead of an
external power supply.
Troubleshooting
If the cradle does not work after following the previous procedures:
• Check the system power.
• Check for loose cable connections.
• Check that the scanner is inserted properly in the cradle.
• Check that the host settings are correct and the cradle is connected to the
appropriate port on the host.
Wall Mount Template
Refer to the English version of this guide (p/n 72-93912-xx) for a wall mount
template.
Charging Use LED Sequences
Green Slow Flash The scanner
charges at the slow rate (used when the cradle is
powered by the host cable).
Green Fast Flash The scanner charges at the fast rate (used when cradle is
powered from an external power supply).
Red Flash Charging problem. Refer to the Product Reference Guide for
more information.
Red and Green
Flash
Temperature fault.
CAUTION Do not pour, spray, or spill any liquid on the cradle.
To Next Page
Loading...
