Troubleshooting
52
Message not
received
Confirm radios have the same channel and interference
eliminator code settings.
Make sure M
is NOT being pressed while trying to listen.
Reposition, replace, or recharge batteries.
If QuieT6000 feature is on, transmit call tone before talking.
If QuieT6000 feature is on, with only VibraCall
®
alert
selected, a received call must be acknowledged by pressing
any button (or a VOX activation) before the radio can receive
any incoming transmissions.
Obstructions and operating indoors, or in vehicles, may
interfere -- change location.
Verify that the radio is not in Scan mode.
Eavesdrop Reducer code is on, or setting does not match
other radios; all radios must use the same Eavesdrop
Reducer code.
Symptom Try This:
To Next Page
Loading...
