EasyManua.ls Logo

MotoTec Drifter - Troubleshooting Guide; Power and Indicator Issues; Motor, Brake, and Speed Problems

MotoTec Drifter
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLE SHOOTINNG GUIDE
(for professional use only)
Problem Cause Solution
The power light 1.Battery is 1.Recharge your tri scooter.
by the thumb discharged. 2.Remove the screws that hold the
Throttle dose not 2.Loose connection battery compartment cover and
Illuminate when inside the tri scooter raise the cover.Visually inspect all
the tri scooter is 3.Fuse us blown there are no loose wires,
On reconnecting those that are.
3.Replace the fuse.
The power 1.The throttle handle 1.Replace the throttle
Indicator by the is not operating handle.Contact your local dealer
Thumb throttle properly. to order a new throttle.
Illuminates but
Tri scooter still
Dose not work
Clicking noise 1.Brush in motor 1.Replace motor.Call your local
Coming from has com loose dealer to order a new 350W
Motor motor
When the brake 1.The brakes are 1.Adjust the brake by loosening
Lever is squeezed not adjusted the bolt on the rear brake wheel,
The tri scooter properly. Pull the cable and retighten the bolt.
Dose not stop.
Scooter is losing 1.Low battery 1.Recharge your battery for6-8hours
Speed. 2.Battery is old. 2.Replace battery.Call your local
Dealer to order a new 36V battery.