- check the brake cables and brake efficiency
- check the lubrication and tension of the chain. Any slack of the chain should be adjusted
to 5 mm.
- After every ride, clean your bike carefully and keep it clean.
B – Every 10 hours of riding:
- check the tightness of all bolts and nuts.
- wash the air filter in petrol and lubricate it with air filter oil.
- clean the carburetor float chamber carefully
- Check the brake pads – the thickness must not be less than 1 mm.
C – Every 50 hours of riding:
- Check the state of the clutch pads – the thickness must not be less than 1 mm.
Shut the engine off when performing maintenance check-ups. Otherwise you should be
severely injured if your hands or clothing get caught by moving parts.
Make sure the engine and exhaust are cold before performing any inspection of the
machine.
DRIVE CHAIN ADJUSTMENT
Make sure not to over tighten the chain, it is important to lubricate the chain regularly, to
avoid excess wear.
Riding with a chain in poor condition or improperly adjusted can lead to serious injury.
Always inspect, adjust and maintain the drive chain properly before each ride.
BRAKE ADJUSTMENT
Failure to inspect and properly maintain the brake increases the risk of having an accident.
Before each ride, check the rear brake cable and the brake efficiency. Riding with worn brake pads
can reduce the braking performance and cause an accident. Check and replace brake pads.
TYRE CHANGE
Using worn, improperly inflated, or incorrect tyres will reduce stability and can cause an
accident.
STORAGE PROCEDURE
If the vehicle is to be left unused for a period of time, it is recommended to drain out all the
fuel from the fuel tank and carburetor. Inflate the tryes to the normal working pressure. Remove the
spark plug, clean it, put a few drops of motor oil into the cylinder, pull the starter rope 2-3 times, so
an oil film evenly coats the cylinder walls and piston. Re-install the spark plug.
How To Change The Clutch
To Next Page
Loading...