Motrona touchMATRIX IX350

To Next Page

Operating Manual

motrona GmbH, Zeppelinstraße 16, DE - 78244 Gottmadingen, Tel. +49 (0) 7731 9332-0, Fax +49 (0) 7731 9332-30, info@motrona.de, www.motrona.de

touchMATRIX® Indicator IX350 / IX355

SSI indicator for absolute encoders, with touchscreen and graphic display

Product features:

 Master or Slave operation with clock frequencies up to 1 MHz

 For single turn and multi turn encoders with SSI formats from 10 … 32 Bit

 Bright and high-contrast display with event-dependent color variations

 Emulation of a 7-segment display inclusively icons and units

 Intuitive and easy parameterization by plain text and touchscreen

 5 V / 24 V auxiliary output for encoder supply

 Linearization with 24 control points

 Numerous features, e. g. scaling, bit blanking etc.

 3.78 x 1.89 inch norm panel housing and IP65 protection

Available options:

IX350: Basic unit with SSI interface, 3 control inputs, 24 VDC encoder supply

IX355: Basic unit like IX350, with open-circuit monitoring, 5 / 24 VDC encoder supply

 Option AC: Power supply 115 / 230 VAC

 Option AO: 16 bit analog output, 4 control outputs, serial RS232 interface

 Option AR: 16 bit analog output, 4 control outputs, serial RS485 interface

 Option CO: 4 control outputs, serial RS232 interface

 Option CR: 4 control outputs, serial RS485 interface

 Option RL: 2 relay outputs

Options can be combined

Main Page

Need help?

Do you have a question about the Motrona touchMATRIX IX350 and is the answer not in the manual?

Summary

Safety Instructions and Responsibility

General Safety Instructions

Provides essential safety rules, warnings, and liability information for the unit's operation.

Intended Use and Precautions

Defines the unit's specific industrial application and limitations, including safety precautions.

Installation and Wiring

Details requirements for safe installation, ventilation, wiring, and electrical connections.

Electrical Connections and Interfaces

DC Power Supply and Auxiliary Outputs

Details DC power supply requirements and auxiliary voltage outputs for sensors/encoders.

SSI Interface Inputs

Explains wiring and configuration for SSI inputs in Master and Slave modes.

Control Inputs and Analog Output

Serial Interface and Control Outputs

AC Power Supply and Relay Outputs

Display and Touchscreen Operations

Error Message Handling

Lists common error messages, their causes, and the unit's behavior during errors.

Parameter and Menu Structure

General Menu Settings

SSI Properties Configuration

Configures SSI mode, resolution, bit format, and baud rate.

Preselection Values and Menus

Serial, Analog, and Command Menus

Display and Linearization Menus