EN
8.2 Assembly of the mincer head
- Take the body (k3) by the feeder tube with the largest opening uppermost.
Next insert the screw (k5) (long axis first) into the body.
- Fit the cutter (k6) on the short shaft, ensuring the sharp edges are facing
outwards.
- Place your chosen grille (k7-1 or k7-2) on the cutter, fitting the lugs into
the corresponding notches on the head (k3).
- Tighten the nut (k8) firmly on the body (k3) in a clockwise direction,
avoiding over-tightening.
- Check the assembly. The shaft should be tight-fitting and not pivot or rotate.
If this is not the case, then repeat the preceding steps.
- Clip the food guide (k4) under the mincer head (k3).
8.3 Fitting the mincer head to the appliance
- With the appliance switched off and unplugged, join the mincer head (k),
with its feeder tube tilted to the right, to the adapter. Push the mincer head
as far as it will go onto the adapter (j).
- Bring the feeder tube back up to a vertical position until it locks in to place.
The mincer head (k) will lock automatically onto the adapter (j) as soon
as it is switched on.
- Attach the detachable tray (k2) to the chimney.
- Plug in the appliance.
• Usage and practical tips:
- Prepare all the ingredients you wish to mince. Remove all bones, cartilage
and sinews.
- Chop the meat into chunks (approximately 2 x 2 cm) and place them on the
tray (k2).
- Place a container under the mincer head fitted with the food guide (k4).
- Turn the speed selector (a3) to position 1 or 2 to start the appliance.
- Insert the meat into the feeder tube piece by piece using the pusher (k1).
- Never push food with the fingers or any other utensils.
Do not use your appliance for more than 15 minutes when mincing meat.
- Always ensure that frozen meat is completely defrosted.
9 : STORAGE OF ACCESSORIES
Your food processor is equipped with a storage box (m) which fits inside the
chopping bowl assembly (b). You can use it to store the stainless steel
chopping blade (d), the dough blade (e), 2 disks: vegetable cutting (g) or
emulsifying (f).
10 : LENGTH OF POWER CABLE
For ease of use and storage, you can reduce the length of the power cable by
29
To Next Page
Loading...
Need help?
General
