Moultrie Pro Hunter - User Manual

Turn Drum upside down.
Metal
Drum
Funnel
Short
Bolts
Funnel placement will vary based on the
construction of Drum. When using a metal
Drum, place Funnel inside Drum with small
end of funnel facing down, and attach with
provided Short Bolts, nuts and washers.
When using a plastic Drum, the funnel may need
to be mounted on the outside. Select the funnel
placement based on the ability to have a 1/2” to
5/8” gap between the bottom of the Funnel and
the horizontal section (center) of the Spinner
Plate as shown below.
Place Feeder on Drum.
Attach Feeder Legs to Drum as
shown with Bolts using nuts and
washers provided.
F e e d e r L e g H o l e s
Turn drum over, measure and mark the center of the bottom.
Center the provided template on the bottom of the drum
and secure with tape. Drill two 3/16" Funnel Holes and
three 5/16" Feeder Leg Holes.
Using a Hole Saw, drill a 2-1/4" hole in the center of the
bottom of your drum.
CAUTION: WEAR EYE PROTECTION
THANK YOU for your purchase of the Pro Hunter Feeder Kit.
Please read this sheet before operating the unit. If you should have
any questions about this product or any other Moultrie product,
please contact us using the information on the back of this sheet. To
help us to better serve you, please complete and mail the enclosed
Warranty Card.
DRILLING YOUR DRUM/BARREL/BUCKET
MOUNTING THE FEEDER
NOTE: This equipment has been tested and found to comply with the limits for a C lass B digital device pursuant to Part 15 of the FCC rules. These limits are des igned
to provide reasonable protection against harmful interference in a residential i nstallation. This equipment generates, uses and can radiate radio frequency ener gy and, if
not installed and used in accordance with the instructions, may cause harmful in terference to radio communications. However, there is no guarantee that interfer ence
will not occur in a particular installation. If this equipment does cause harmfu l interference to radio or television reception, which can be determined by turn ing the
equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and the receiver
Pro Hunter will mount to the bottom of any drum or bucket
Funnel Holes
Instructions for Pro Hunter Feeder Kit
Drum
Feeder Legs
Feeder
Bottom of Funnel
Horizontal section
of Spinner Plate
1/2” to 5/8” gap

Summary

Drilling Your Drum;Barrel;Bucket

Safety Precautions for Drilling

Advises wearing eye protection before starting the drilling process for feeder installation.

Drum Preparation and Drilling

Instructions for marking the drum center and drilling funnel and feeder leg holes.

Mounting the Feeder

Funnel Placement and Drum Preparation

Guides funnel placement based on drum type (metal vs. plastic) and required gap.

Feeder Attachment to Drum

Steps for attaching the feeder legs to the drum using provided bolts, nuts, and washers.

Installing Battery

Battery Installation and Connection

Details battery options (6V, D-Cell) and correct connection of clips to feeder terminals.

Configuring and Testing Feeder

Setting Feed Times and Duration

Instructions to set specific feed times and the duration of each feeding cycle.

Testing Feeder Operation

Guide on how to test the feeder's run-time seconds and assess feed dispensing.

Tips and Troubleshooting Guidance

Provides advice on battery selection and troubleshooting common feeder issues.

Moultrie Pro Hunter Specifications

General

Type	Feeder Kit
Power Source	6V Battery
Programmable Timer	Yes
Feed Duration	1-20 seconds
Feed Times	Up to 6 per day
Motor	High-torque
Housing	Plastic