Moultrie Super Pro Magnum Feeder User Manual

Instructions for Super Pro Magnum Feeder
Thank you for your purchase of the Super Pro Magnum Feeder. Please read this sheet
before operating the unit. If you should have any questions about this product or any other
Moultrie product, please contact us using the information on the back of this sheet.
DRILLING YOUR DRUM OR BARREL
A
MOUNTING THE FEEDER
B
Turn drum over, measure and mark the center of the bottom.
Mark where holes of kit are on the bottom of the drum.
Drill three 5/16” Feeder Leg Holes.
Using a Hole Saw, drill a 2.25” hole in the center of the
bottom of your drum.
From the inside of the drum, put at washers on the 1/4-20 x 4”
Combination Drive Screws then slide through the holes in the
bottom of the barrel and screw the push nuts onto the bolts on
the outside of the barrel.
Slide feeder over three Bolts that are sticking rmly through
the bottom of the drum. Attach Feeder Kit to the Drum
using the three provided Wing Nuts.
Super Pro Magnum Kit will mount to the bottom of any drum or barrel
NOTE: If you purchased a Moultrie barrel, go to Step B
Combination Drive Screw
Qty. 3
(¼”-20 x 4”)
Flat Washer
Qty. 3
(¼”)
Push Nut
Qty. 3
(¼”)
Wing Nut
Qty. 3
(¼”)
HARDWARE INCLUDED:
Push Nut
Combination
Drive Screw
Turn grooved handle counterclockwise one click . This will release
the battery cover from the feeder kit. Battery cover can be pulled
o straight downward and set aside.
NOTE: Grooved handle should stay assembled with battery cover.
DO NOT FORCE THE GROOVED HANDLE COUNTERCLOCKWISE
AN ADDITIONAL CLICK. This will disassemble the grooved handle
from the battery cover and can cause wear on the parts that
retain this assembly.
Bolts
Super Pro Magnum
Feeder Kit
Wing Nuts
Drum
Flat Washer
O
F
F
O
N
MFG-13455_Super Pro Magnum Kit_Manual-ENGLISH_4-19-22.indd 1MFG-13455_Super Pro Magnum Kit_Manual-ENGLISH_4-19-22.indd 1 4/19/22 9:56 AM4/19/22 9:56 AM

Moultrie Super Pro Magnum Feeder Specifications

General

Brand	Moultrie
Model	Super Pro Magnum Feeder
Category	Fishing Equipment
Language	English

Summary

Drilling Your Drum or Barrel

Mark and Drill Feeder Leg Holes

Mark and drill three 5/16" holes for feeder legs on the drum bottom.

Drill Center Hole

Drill a 2.25" center hole in the drum bottom using a hole saw.

Mounting the Feeder

Secure Feeder Kit to Drum

Attach feeder kit to drum using screws, washers, push nuts, and wing nuts.

Install Belly Band Ring

Slide Belly Band Ring onto the drum and secure with bolt, spacer, and lock washer.

Installing Battery

Connect Battery Terminals

Attach alligator clips to the positive and negative terminals of the 6-volt battery.

Secure Battery Cover

Replace battery cover and rotate grooved handle clockwise to secure.

Stand Up Feeder and Install Lid

Assemble and Position Feeder

Assemble leg sections, then rotate feeder upright onto three legs.

Add Feed and Install Lid

Add feed to the feeder, then install and tighten the lid securely.

Configuring and Testing Feeder

Set Current Time and Day

Program the feeder's current time and day of the week.

Configure Feed Settings

Set feed times, run duration, days of the week, and motor speed.

Perform Test Feed

Enter test mode to set test duration, motor speed, and commence test.