Mound Yeti 2 - Power Sources and Electrical Requirements; Extension Cord Specifications; Grounding and GFCI Outlet Safety; Generator Usage and Safety Precautions

MOUND YETI 2 INSTRUCTIONS
1-800-463-6865
5
TM
Power Sources
Your machine requires a standard 110 volt, AC power supply. For an Alternate source, you may use a generator. Be sure the
generator has an output of at least 1400 watts.
EXTENSION CORD:
Use only a 3-wire cord that has a 3-prong plug and 3-pole receptacle that will accept the power cord plug on the machine. Use
only an extension cord that is rated for outdoor use. It is important to use a cord with the proper wire gauge size. The longer the
cord, the bigger the wire must be. (The smaller the guage number, the larger the wire.) Refer to the chart below for the proper
size.
Length Gauge of Wire
25 feet 16
50 feet 14
100 feet 12
150 feet 10
200 feet 08
GROUND THE MACHINE:
Your machine is manufactured with a 3-prong grounding plug and must be plugged into an extension cord as detailed above.
Proper grounding is essential to insure your safety should a malfunction occur, the unit must be connected to a GFCI outlet that
meets all local and state codes. If you have any doubts about the electrical connections, contact a licensed electrician.
USING A GENERATOR:
Start the generator
Plug the surge protector into the generator
Plug the pitching machine into the surge protector
Turn on the pitching Machine
CAUTION: ALWAYS USE A SURGE PROTECTOR WHEN USING A GENERATOR.
POWER SURGES CAN DAMAGE THE SPEED CONTROLLERS.