Mound Yeti 2 - Machine Handling and Safety Information; Pre-Use Inspection Checklist; General Operational Safety Precautions

MOUND YETI 2 INSTRUCTIONS
1-800-463-6865
8
TM
TRANSPORTING THE MACHINE
• Rotate pitching wheels to their horizontal position
• Loosen the swivel lock handle on the tripod base and rotate the machine until two of the legs are parallel with the transport
wheels
• Now, with the help of a second person, lower the machine to the floor by holding onto the frame.
• Pick up the two legs and roll the machine on the wheels to the desired location
• Do not let the pitching wheels touch the ground while rolling the machine. Do not roll over rough or uneven terrain.
BEFORE EACH USE
• Check that all nuts, bolts, and levers are tight
• Check the power cord for any cuts or abrasions
• Check that pitching wheels are in good condition - no cracks, no missing chunks, and no excessive vibration
STORAGE
• Store machine in clean, dry area
• Cover the machine when not in use. CAUTION: do not use a plastic cover. Plastic will sweat and cause damage to your
machine.
• Pitching wheels should never be left in the sunlight or high heat areas for prolonged periods. This can cause the material to
deteriorate.
IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS AND WARNING LABELS
Become familiar with your machine before using. Know its potential and limitations.
INSPECT THE MACHINE BEFORE EACH USE.
The wheels must be clean and free of any cracks in the urethane. Clean the machine and wheels with a clean damp cloth. Never
use chemicals or solvents. Be sure to tighten all levers after each setting change.
SHOCK HAZARD
Use and store this machine only in a dry location. DO not use if the machine becomes wet. Wipe any water from the amchine
and allow to completely dry before using again.
EXTENSION CORD
Use only a 3-prong power cord. I fhte ground prong has been broken off, do not use. Use a power cord with the proper guage
wire for the length you are using. (see chart for proper size). An under size cord will cause a drop in voltage and will cause
overheating. Do not use a cord that is cracked or otherwise damaged. Keep cord away from moving wheels. Be sure cord on
ground does not present a tripping hazard.
DO NOT TOUCH ROTATING WHEELS
Make no adjustments or move the machine until the wheels are completely stopped