Removing the Sunhood
1. Standing beside your stroller and using a
reasonable degree of force, pull the sunhood
support wire towards you (by about 50mm/2in).
2. Remove support wire W from sunhood bush J on
the side nearest to you.
3. Unfasten sunhood domes that
attach the sunhood to stroller
frame and to stroller seat back.
Removing the Seat
1. Unfasten domes on seat that attach to frame.
2. Urban (Jungle) Only: unfasten strap
underneath seat at point A.
3. Terrain Only: remove seat support wire from
stroller frame at C and D. Push seat forward,
then slide fabric o seat
support wire.
W
J
C D
Before you can attach the Carrycot to your stroller you will need to remove the fabric
sunhood and seat on your stroller.
Preparing your stroller to fit the Carrycot
A
To Next Page
Loading...
