These instructions are for the Single Carrycot, which fits the following
model strollers:
Te r rain Single - T1204 Urban Single - U1204
SINGLE CARRYCOT INSTRUCTIONS
IMPORTANT, KEEP FOR FUTURE REFERENCE
ASCis1/3/04gen
1
WARNING
• Do not use this Carrycot until you have read and
understood the instructions!
• Carrycot is suitable for newborn baby to 6 months, or
until baby can sit up unaided.
• Before placing baby into position check that the
Carrycot is secure and will not tip or fall.
• Baby must not be in the Carrycot when it is being
fastened or removed from the stroller frame.
• The depth from the top of the mattress to the top of
the side of the Carrycot at, or at any position within
300mm/11.8in from the harness attachment points,
should not be reduced to less than 140mm/5.5in when
the mattress is in position. Mattresses purchased
separately should conform to BS1877 part 10.
• Do not use accessories not designed for your stroller
as they might be unsafe.
• Do not use the Carrycot to transport children in a
motor vehicle.
•Never leave your child unattended.
• Sunhood and seat need to be removed from stroller before fitting Carrycot.
• Store items removed in a dry safe place.
Unfasten seat from frame along
side tubes.
Unfasten strap underneath seat
at point A (does not apply to Terrain
model).
Push seat forward, then slide
fabric off seat support wire.
Remove seat support wire
from stroller frame at B and C.
3
1
2
Removing Seat
4
STAGE 1
Pull support wire out of
sunhood joint A. This
operation is child proof and
therefore requires a degree of
force. To assist in pulling
support wire out, push
against buggy frame with other
hand B.
Repeat step (1) on other
side.
Unfasten sunhood fabric
from stroller frame and seat
near handle bar.
3
1
Removing Sunhood (both models)
2
A
B
Sunhood Joint
These instructions are for the Single Carrycot, which fits the following
model strollers:
Te r rain Single - T1204 Urban Single - U1204
SINGLE CARRYCOT INSTRUCTIONS
IMPORTANT, KEEP FOR FUTURE REFERENCE
ASCis1/3/04gen
1
WARNING
• Do not use this Carrycot until you have read and
understood the instructions!
• Carrycot is suitable for newborn baby to 6 months, or
until baby can sit up unaided.
• Before placing baby into position check that the
Carrycot is secure and will not tip or fall.
• Baby must not be in the Carrycot when it is being
fastened or removed from the stroller frame.
• The depth from the top of the mattress to the top of
the side of the Carrycot at, or at any position within
300mm/11.8in from the harness attachment points,
should not be reduced to less than 140mm/5.5in when
the mattress is in position. Mattresses purchased
separately should conform to BS1877 part 10.
• Do not use accessories not designed for your stroller
as they might be unsafe.
• Do not use the Carrycot to transport children in a
motor vehicle.
•Never leave your child unattended.
• Sunhood and seat need to be removed from stroller before fitting Carrycot.
• Store items removed in a dry safe place.
Unfasten seat from frame along
side tubes.
Unfasten strap underneath seat
at point A (does not apply to Terrain
model).
Push seat forward, then slide
fabric off seat support wire.
Remove seat support wire
from stroller frame at B and C.
3
1
2
Removing Seat
4
STAGE 1
Pull support wire out of
sunhood joint A. This
operation is child proof and
therefore requires a degree of
force. To assist in pulling
support wire out, push
against buggy frame with other
hand B.
Repeat step (1) on other
side.
Unfasten sunhood fabric
from stroller frame and seat
near handle bar.
3
1
Removing Sunhood (both models)
2
A
B
Sunhood Joint
To Next Page
Need help?
General
