11
MAINTENANCE
Stop the engine and disconnect the spark plug lead before working on the machine.
DO NOT TIP THE MOWER ONTO ITS SIDE AS THIS WILL FLOOD THE AIR FILTER WITH OIL.
To access the underside of the machine, lift the front wheels by lowering the handle until it rests on the ground.
CUTTER BLADE
Examine the cutter blade regularly for wear or damage.
• A slightly worn blade can be re-sharpened by your local dealer
• If the blade is damaged it should be replaced. Replacement blade kits are available from
your Mounteld stockist or B&Q store. The part number for the blade kit is MS1196. If in
doubt refer to your dealer, or telephone 0800 121 6585.
Blade must always be marked with part number
81004365/3
CLUTCH CABLE ADJUSTMENT (Self Propelled model only)
• Make sure that the clutch lever is fully released.
• Slacken the bottom nut and then tighten the top nut on the adjuster to take up any
excess slack in the cable. The cable should have about 12mm of play on it (Figure 7).
• Engage the clutch lever and check that the rear wheels lock when the mower is pulled
backwards.
• Start the mower and ensure it does not drive when the lever is disengaged.
adjuster
cable
Figure 7
ENGINE
An engine Manufacturer’s Owner’s Manual is supplied with your mower.
Please read this, it provides detailed information on engine operation, maintenance and battery care. Repair work
other than routine maintenance, should be carried out by an authorised dealer.
STORAGE
A little time spent on your mower after use will ensure many years of reliable mowing.
To access the underside of the cutter deck, ensure that the spark plug lead is disconnected. Then lift the front wheels
by lowering the handle until it rests on the ground. Do not tip the mower onto its side, as this will ood the air lter
with oil. Failure to maintain and care for your engine may invalidate the machine guarantee. Please see the guarantee
statement for full terms and conditions.
AFTER EACH USE
• Remove any grass pulp from the underside of the cutter deck using a non-metallic instrument such as a piece of
wood. Take care not to damage the paintwork.
• Examine the cutter blade for any damage. A damaged blade may upset the balance of your mower and cause
excessive vibration. If in doubt refer to your dealer.
• Inspect the grass collector and clean it if necessary. If the mesh becomes clogged airow will be reduced and impair
grass collection.
• The handle can be folded down to reduce the amount of storage space required. Take care not to trap any of the
operating cables when folding or unfolding the handle.
• Store the mower in a clean, dry area well away from any naked ames, sparks or heat source
LONG TERM - (if you are not using your mower for more than 28 days)
• Give the machine a thorough clean, paying particular attention to the underside
• Lubricate all moving parts
• Empty the fuel tank either by running the mower out of fuel or tip the machine backwards and onto the back right wheel to
drain the fuel into a suitable container. To drain the carburettor it is necessary to slacken the drain screw. The drain screw
is situated under the carburettor on the oat bowl (see diagram page 4). A bolt holds the bowl in place on the very bottom,
but on an angle slighlty closer to you is another bolt with a red washer. This is the drain screw.
To Next Page
Loading...
Need help?
General
