EN - 4
trations (listed on page iii and following pages).
1. COMPLETE ASSEMBLY
NOTE The machine can be supplied with some parts al-
ready assembled.
WARNING! Unpacking and completing the assem-
bly should be done on a flat and stable surface, with
enough space for moving the machine and its packag-
ing, always making use of suitable equipment.
Disposal of the packaging should be done in accord-
ance with the local regulations in force.
1.1 Assembling the handle
-
of the handle (1) and (2).
Fit the starter cable (8) in the guide (9) and tighten the nut
(10).
Fit the cable fastener (11) in the indicated position and se-
cure the control cables.
1.2 Assembling the grass catcher
illustrated.
2. CONTROLS DESCRIPTION
NOTE The meanings of the symbols on controls are ex-
plained in the previous pages.
2.1 Throttle lever
Lever positions are indicated on the relevant plate.
a throttle.
2.2 Engine brake lever / cutting means
2.3 Drive lever (where applicable)
-
released.
-
gaged.
WARNING! To prevent damage to the transmis-
sion, do not pull the machine backwards with the
transmission engaged.
2.4 Cutting height adjustment
3. GRASS CUTTING
NOTE This machine can be used to mow lawns in a
number of different ways; before starting work, prepare the
machine based on how the lawn is to be mowed.
DO THIS WHEN THE ENGINE IS OFF.
3.1 Preparation for mowing and grass collection by
the grass catcher
Lift the rear discharge guard (1) and fasten the grass catch-
3.2 Engine ignition
-
3.3 Mowing the lawn
When the grass catcher is too full, grass collection is no
– lift the rear discharge guard, grasp the handle and re-
Lawn care recommendations
“spotted” appearance;
-
3.4 End of operations
WAIT UNTIL THE CUTTING MEANS STOPS before pro-
4. ROUTINE MAINTENANCE
IMPORTANT Routine and accurate maintenance is es-
sential in maintaining original machine safety and perform-
ance levels.
-
-
ble disconnected.
-
To Next Page
Loading...
Need help?
General
