FAULT FINDING
CERTIFICATE OF CONFORMITY
PROB LEM SOLUTIO N
Engine will not start
Check there is ample clean, fresh fuel in the tank.
Check the cutter blade is not fouling the ground preventing free rotation.
Engine will not stop
Check the Operators Presence Control (OPC) lever is fully released.
Rem ove spa rk plug le ad to stop en gine usin g insulated gloves and refer to d ealer.
Engine hunts and stops Rem ove fuel ca p to release air lo ck and replace it just finger tigh t, do n ot o ver-tighten .
Failure to cut grass properly
Stop the engine an d disconnect the spark plug lead using h eat resistant gloves.
Check blade attachment bolt is tight.
Check condition of blade. If seriously worn or damaged replace with a new one.
A certificate of conformity is enclosed with the documentation as separate document.
An EXAMPLE is shown below.
19
EXAMPLE
To Next Page
Loading...
Need help?
General
