Mountway Smart Charger User Manual (English)

To Next Page

Mountway Bath Lift Smart Charger Instructions

This charging guide must be used in conjunction with your bath

lift’s full operating instructions.

Before rst operation of your bath lift or after long periods of non-use

(typically 7-10 days), fully charge the battery as follows. A at battery will

take up to 2 hours to charge.

i) Slide the battery into the track on the charging cradle until it clicks into

place.

ii) Plug the charger into the mains socket/power outlet outside the

bathroom and switch on the electricity supply. (Note: Ensure you

charge on a hard surface and DO NOT cover the battery or charger.)

iii) The light indicator on the charger box will initially ash in a quick

sequence of red, green, red, green. After a few seconds, a constant red

light appears to indicate charging is in progress.

Battery

Charger

Charging cradle

Tracks

Light indicator

Need help?

Do you have a question about the Mountway Smart Charger and is the answer not in the manual?

Mountway Smart Charger Specifications

General

Steps for connecting the battery to the charging cradle and plugging in the charger.

Explanation of the charger's light indicators for charging progress and full charge status.

Crucial instruction to remove the battery from the charging cradle after charging is complete.

Advice on optimal charging frequency and continuous charging for battery maintenance.