EasyManua.ls Logo

Mountz MDC-26 - Page 39

Default Icon
59 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Screw
count
Screw
count
Sensor signal type 0 - 3 242 0
Time limit (if P122-->2) 243 0
Count complete OUT manage 244 0
Middle count no. 0 - 99 245 0
Sensor signal delay time (x10ms) 246 0
Total count (screw no.) 247 5
Crowfoot Crowfoot
265
266
267
268
269
Controller
Setting 1
Run time limit / Forward (sec) 270 10
Run time limit / Reverse (sec) 271 10
Motor stall time limit (sec) 272 0.2
Loosening speed (rpm) 273 Auto
Motor acceleration (ms) 274 100
Fastening complete signal OUT time 275 0
Driver ID no. 276 1
Error display reset time 277 1
Torque compensation master (%) 90-110 278 100
Use max torque for Loosen 279 0
Initial preset # when power ON 280 1
Driver model no. 1-99 281 selectable
Password 0-9999 282 0
Parameter initialize to factory setting 283 0
Driver auto lock (for Model) 284 0
Selection on panel 285 0
Torque holding time(ms) 1-20 286 2
mountztorque.com - 1080 N 11th St, San Jose CA 95112 - 408.292.2214
39