38
7
SEAT
The seat has a regulation that allows the user to adjust in the best possible way. If the adjustment
is not being made it is possible that something has broken in the seat. Do not attempt or allow
the equipment to be used. If this happens contact a Technical Support.
MAINTENANCE
TOP PLATE
Allows the weight to be selected. At the slightest damage or wear the parts does not try to select
the weight. Contact Techinical Assistance to make the change
LOCKING STEEL CABLE
Always check that the screws are securely fastened to the plates. If the locks are damaged, do
not allow the equipment to be used. Contact Technical Assistance to make the change.
SNAP LINK
Some models use snap link, so it is extremely important to check the condition of the carabiner.
At the slightest sign of wear, deformation, difficulty to close and anything that could be
detrimental to its resistance, replace the snap link immediately
REPLACEMENT CARABINER
For the replacement, always use a snap link supplied directly by MOVEMENT. If it is not possible
to obtain a snap link supplied by MOVEMENT, use a snap link that strictly meets the following
requirements.
-Material composition: Stainless steel AISI 316;
- Maximum closed capacity: 1600kg;
- Maximum open capacity: 350kg
ATTENTION!
- Monthly, verify with attention the conditions
of the snap link;
- Do not modify the snap link in any way;
- The opening of the snap link must be
turned to the weights column.
RODS
For a better conservation of the equipment, it is necessary that the rods of the equipment are
always cleaned weekly. Clean using a cloth moistened with water or alcohol.
To Next Page
Loading...
