Moza iFocus - Getting Started; Mount the Lens Gear Ring; Mount the Motor

2
1. Mount the Lens Gear Ring
a. Fits the lens gear ring with your camera lens.
b. Tighten the clip.
a. Loosen the knob(1) on the quick-release mount and slide the motor onto the
support rod(2).Tighten the knob to secure the motor’s position on the support
rod.
Note: Ensure the clip is tight and that the lens gear ring makes good contact
with the lens.You may also use a standard 0.8 Mod lens gear ring of your own.
b. Tighten the knob(1) to secure its position. Ensure the motor gear(2) and lens
gear ring(3) make good contact.
2. Mount the Motor
Getting Started