Chapter 2 - Installation
2.1 - General Information
Failure to comply with the following requirements may prevent the correct
operation and safety of the product.
1. All installation, connection and adjustment operations must be performed only
by qualified personnel and according to the specific properties of the device;
2. During installation it is important to verify that the gas flow is in accordance with
the arrow on the valve body;
3. To avoid damage that may compromise correct functioning of the valve, do
not exceed the tightening torques listed in next chapters;
4. To avoid damage that may compromise correct functioning of the valve,
handling of valve shall be taken care of: avoid falls and bumps;
5. To avoid damage that may compromise correct functioning of the valve, use
the appropriate tools for installation operations;
6. In order to avoid any foreign body to enter into the valve, which could
compromise the right functioning of the valve, manifold shall be clean. A
suitable filter should be mounted on the manifold supply inlet.
After installing or replacing the valve / valves, the installer must
always check for gas leakage.
To Next Page
Loading...
Need help?
General