WARNING
HEART RATE :
The physical condition of an individual might affect the intensity of the hear rate
signal.
Avoid using the heart rate close to trolley car, tram stop, transformer, electric
substation and high-tension distribution line, etc. The radio signal will be affected
under the environment of high voltage and strong magnetic fields leading to wrong
heart rate results.
Take care of your chest belt. Wash the chest belt with suds and flush with water.
Let it dry naturally. Avoid to place the chest belt under the environment of high
temperature. Don't touch the corrosive materials with acids or alkalis.
To ensure your safety, please use the Heart Rate Transmitter only under a doctor
or coach's direction if you have one of the following conditions:
a. Cardiopulmonary disease
b. Obesity
c. No exercise for a long period of time.
HEART RATE CONNECTION
Press L + R button together for 2 seconds
BATTERY CHARGE STATUS INDICATOR B
The battery charge status indicator B shows the charge status of the e-Bike's battery.
Each bar on the indicator is equivalent to a capacity of approx. 20 %:
100% Battery
app.40% Battery
recharge Battery
When the battery status indicator shows an empty battery the motor will gently switch
off.
The remaining battery is made available for the lighting function. When the battery
frame indicator starts to flash the lights can still be used for rd. 2more hours.
This doesn't account for other consumers (e.g. automatic gearbox, charging external
devices at the USB port).
Technical modifications, changes and errors excepted
www.mpfdrive.com 9
Technical modifications, changes and errors excepted
www.mpfdrive.com 10
COMPUTER SETUP
RESET THE COMPUTER (ALL CLEAR)
Press A to reset the computer and delete all data for first usage or after
battery change.
Press any key to stop display auto test and to enter unit setting mode.
UNIT SELECTION (press button A )
1. Press L or R button to choose the unit MPH or KPH.
2. Hold M button for 1 second to enter Clock setting mode.
CLOCK SETTING
1. Press M button to select between the digits to be set.
2. Press L to decrease the number.
3. Press R to increase the number.
4. Hold M button 1 second to change to chest belt pairing mode.
CHEST BELT PAIRING MODE
1. Put on the chest-belt.
2. Press R button to start the pairing procedure.
3. Display will show āERRORā if pairing fails-press R button to start pairing procedure
again.
4. Press S button to save all the setting data and to return to the General mode
operation.
CHANGE BETWEEN HEART RATE OR REMAINING RANGE
Press buttons L + R together to change between heart rate or remaining range.
To Next Page
Loading...