7. Install, start and use PrintGuide (can be downloaded from
https://www.mpitech.com/ under “Support”, “Software
downloads”) for assigning the IP address of the target
printer.
Generate Settings Printout
Make sure that both the PrintServer and printer are powered
on. And please ensure that PrintGuide has been used to
assign an IP address for the destination printer, and that
settings have been saved.
Pressing the test button once will print out test page(s), of
the LinkCom V S configuration, on the configured printer.
The test button is located on the PrintServer’s rear panel.
Please note that the printer must support Ascii in order for the
test page to be printed.
Please consult the user guide for detailed setup and trouble
shooting. All documentation can be downloaded from the MPI
Tech website: https://www.mpitech.com under “Support”,
“Manuals & Quick Guides”.
To Next Page
Loading...
