11
EN
DESCRIPTION OF THE APPLIANCE
1. Turn on/off knob - two operation
modes + PULSE function
2. Blender housing made of stain-
less steel
3. Blender glass jug (1000 ml)
4. Handle
5. Stainless steel knife
6. Jug mounting base
7. Jug lid
8. Hole plug in the jug lid with
scale
9. Blender bottle (600 ml)
10. Bottle cap
11. Bottle mounting base with
knives
12. Closable opening
13. Holder
14. Non-slip feet
ASSEMBLY OF THE JUG
1. Turn the jug (3) so that the base
mounting hole is positioned up-
wards.
2. On the mounting base of the jug (6)
put a gasket and a knife (5) in such
a way that the fixing tongues of the
blade base are correctly seated in-
side the jug mounting base. Next turn the knife home counter-clockwise.
3. Put the jug mounting base (6) with the knife (5) on the blender jug (3).
4. Tighten the mounting base to the blender jug paying attention to adjust the thread properly.
To disassemble the blender knife reverse the assembly procedure.
NOTE! Knives of the appliance are sharp. Handle them carefully.
8
7
3
4
13
12
10
9
11
fig. 1
5
6
2
1
14
To Next Page
Loading...
Need help?
General
