11
GB
5. Put the bottle upside down and place it with the bottle base ring on the device body so that
the two tabs from the base ring are inserted in the holes in the blender base, then press the
bottle downwards and tighten it clockwise to the max.
WARNING! The device knives are sharp. Handle with care.
In case of the disassembly of the bottle, follow the above steps in the reverse order.
WARNING! Do not use the appliance if the container is empty.
6. Plug the power cord into the wall socket.
7. Start the device by pushing and holding the button (1) low speed or (2) high speed..
8. After mixing the bottle contents, switch the device off by releasing the button (1) or (2) and
remove the plug of the power supply cable from the mains socket.
9. Remove the bottle (5) with the base ring (4) from the blender casing (3).
10. Turn the bottle (5) to its normal position.
11. Loosen the bottle base ring (4).
12. Put the cap (6) on the bottle top (5), making sure that the thread is matched properly. Both
caps have the same size and can be used interchangeably.
13. Tilt the plug (7) in the bottle cap (6) fill the bottle up; push the plug to close the bottle and
store its contents
CAUTION! Do not run the motor for more than 60 s as it may overheat. After 60 s switch the device off until the
motor cools down.
USERELATED NOTES
1. Cooked vegetables and brew should cool down before you pouring them into the blender.
2. The blender is not intended for the following actions:
- grating potatoes
- beating eggs or products for replacing dairy
- mincing raw meat
- beating or mixing heavy dough, as it can lead to forming a lump which may damage the
appliance
- draining juice off fruits and vegetables
- cracking ice or frozen foodstuffs.
3. Every few seconds check the consistency of ingredients being mixed.
4. Do not exceed the maximum permissible operating time of the appliance specified in its user
manual.
5. If the motor stops, immediately stop the mixing or decrease the number of ingredients in
the bottle.
CAUTION! Do not remove the bottle from the casing when the device is on.
CLEANING AND MAINTENANCE
1. The blender elements are resistant to corrosion and easy to clean.
2. Disassemble the blender elements before and after each use, thoroughly wash them with
warm water mixed with a detergent, rinse them down and dry them.
To Next Page
Loading...
Need help?
General
