MPM MEK-01 - Page 14

14
EN
 Do not tug on the power cable or on the appliance itself to
remove the plug from the socket.
 When you don’t use the appliance disconnect it from the
power supply.
 For safety reasons, the appliance should never be opened.

Use the device on a smooth, even, dry, horizontal and stable
surface.

The power cord must not be replaced by the user.In case of
cord damage send to an after sale service center approved
by the manufacturer.

When the appliance is not in use switch it off and unplug it.
 Only connect the device to a grounded power source.

ATTENTION! The device blows hot air. Be careful not
to burn yourself.
 Before connecting the device to the mains, check that the
device switch is in the “0” position.
FAN HEATER OVERVIEW
1. Control panel
a. on/o switch of the device
b. on/o switch of the 1st heang
level (1750W)
c. on/o switch of the 2nd heang
level (1950W)
d. thermostat knob
e. illuminator brightness knob
2. Device housing
3. Device feet (4 pcs.)
4. Doors
5. Door handle
6. Electric porthole
7. Air intake grille
8. Air outlet grille
SWITCH POSITIONS:
O - o
I - enabled