MPM MEK-01 - Cleaning and Maintenance

15
EN
BEFORE FIRST USE
1. Remove the fan heater from the box and discard all bags, sckers and lling materials.
2. Inspect the fan heater for damage during transport. If you suspect the fan heater is damaged, do
not use it and contact the seller.
3. Using a screwdriver, thread the three included screws through the
holes in each leg as shown and ghten them counterclockwise to
the boom of the appliance.
ATTENTION! Do not operate the device without properly
installed feet.
4. During the rst start-up, the device may emit a warming smell - it
will disappear during further operaon.
USING THE FAN HEATER
1. Check if the power cord is not damaged
2. Place the appliance on a at, dry, stable, even and horizontal surface
3. Connect the device to the mains
4. Open the door (4) using the handle (5). Start the device with the switch (1a) - the porthole (6) starts
to simulate the eect of burning and glowing wood in the replace.
5. Use the knob (1e) to adjust the brightness of the simulated eect.
6. With the switch (1b) you can start blowing warm air from the grille (8) with a heang power of
1750W.
7. With the switch (1c) you can start blowing warm air from the grille (8) with the heang power of
1950W. However, the switch (1c) will work only aer turning on the 1750W heang.
8. Aer turning on the heang and reaching the desired temperature in the room, slowly turn the
thermostat knob (1d) to the le unl the heang switches o (a faint click should be heard). will
automacally maintain this temperature. To lower the temperature, turn the thermostat knob to
the le. To raise the temperature, turn the thermostat knob to the right.
9. Aer nishing work, switch the switches (1c), (1b), (1a) to the zero posion and then disconnect the
device from the power supply.
ATTENTION! The device is protected by a safety switch that automacally turns o the device if
it ps over or is at an excessive angle to the horizontal. This helps prevent accidents. The device
will resume operaon when placed in an upright posion.
CLEANING AND MAINTENANCE
CAUTION! Before cleaning, always unplug the fan heater from the mains outlet and wait unl it
has completely cooled down.
CAUTION! Do not submerge the fan heater in water or other liquids!
1. Clean the casing and door of the device from dust using a so cloth. Do not use chemicals. Be
especially careful and careful not to damage the device.
2. To remove dust from the air inlet and outlet grilles, you can use a vacuum cleaner with very low
sucon power and a so sucon p.
3. There are no parts in the device that require aenon or maintenance. Do not aempt to open the
outer casing. Doing so may damage the motor and heang element and void the warranty.