MPM MEK-02 - Page 13

13
EN
 Do not tug on the power cable or on the appliance itself to
remove the plug from the socket.
 When you don’t use the appliance disconnect it from the
power supply.
 For safety reasons, the appliance should never be opened.

Use the device on a smooth, even, dry, horizontal and stable
surface.

The power cord must not be replaced by the user.In case of
cord damage send to an after sale service center approved
by the manufacturer.

When the appliance is not in use switch it off and unplug it.
 Only connect the device to a grounded power source.

ATTENTION! The device blows hot air. Be careful not
to burn yourself.
 Before connecting the device to the mains, check that the
device switch is in the “0” position.
FAN HEATER OVERVIEW
1. Control panel
a. switch knob
b. thermostat knob
c. device operaon indicator light
2. Device housing
3. Electric porthole
4. Handle for carrying the device
5. Air intake grille
6. Air outlet grille
BEFORE FIRST USE
1. Remove the fan heater from the box and discard all bags, sckers and lling materials.
2. Inspect the fan heater for damage during transport. If you suspect the fan heater is damaged, do
not use it and contact the seller.
3. When turned on for the rst me, the fan heater may smell of hot electrical appliance. This is
normal and will subside aer some me of use.
USING THE FAN HEATER
1. Check if the power cord is not damaged
2. Place the appliance on a at, dry, stable, even and horizontal surface
3. Connect the device to the mains
4. Pokrętło termostatu (1b) ustaw w pozycji MAX