MPM MEK-02 - Cleaning and Maintenance

14
EN
5. Set the thermostat knob (1b) to the MAX posion:
- I – 1 heang level 750W
- II – 2 heang level 1500W
-
- 1 heang level 750W with a simulaon of burning wood in the replace
-
- 2nd heang level 1500W with simulaon of burning wood in the replace
- 0 – device disabled
Operaon of the device will be signaled by the control lamp (1c)
6. Aer switching on the heang and reaching the desired temperature in the room, slowly turn the
thermostat knob (1b) to the le unl the heang switches o - a so click should be heard and the
control lamp (1c) goes out. The device will automacally maintain this temperature. To lower the
temperature, turn the thermostat knob to the le. To raise the temperature, turn the thermostat
knob to the right
7. To turn o the device, turn the knob (1a) to the „0” posion and disconnect the plug from the
power source.
ATTENTION! The device is protected by a safety switch that automacally turns o the device if
it ps over or is at an excessive angle to the horizontal. This helps prevent accidents. The device
will resume operaon when placed in an upright posion.
CLEANING AND MAINTENANCE
CAUTION! Before cleaning, always unplug the fan heater from the mains outlet and wait unl it
has completely cooled down.
CAUTION! Do not submerge the fan heater in water or other liquids!
1. Clean the casing and door of the device from dust using a so cloth. Do not use chemicals. Be
especially careful and careful not to damage the device.
2. To remove dust from the air inlet and outlet grilles, you can use a vacuum cleaner with very low
sucon power and a so sucon p.
3. There are no parts in the device that require aenon or maintenance. Do not aempt to open the
outer casing. Doing so may damage the motor and heang element and void the warranty.
INFORMATION REQUIREMENTS FOR ELECTRIC LOCAL SPACE HEATERS:
Model identifier: MEK-02
Item Symbol Value Unit Item Unit
Heat output Type of heat input, for electric storage local space
heaters only
Nominal heat output Pnom 1,5 kW manual heat charge control, with integrated
thermostat
N/A
Minimum heat
output (indicative)
Pmin 0,7 kW manual heat charge control with room and/or
outdoor temperature feedback
N/A
Maximum continu-
ous heat output
Pmax,c 1,5 kW electronic heat charge control with room and/or
outdoor temperature feedback
N/A
Auxiliary electricity consumption fan assisted heat output N/A
At nominal heat
output
el
max
0,000 kW Type of heat output/room temperature
control