21
EN
The appliance is intended for keeping food stuff and/ or beverages in normal
household as explained in this instruction booklet The appliance is heavy. Care
should be taken when moving it.
Do not remove nor touch items from the freezer compartment if your hands are
damp/wet,as this could cause skin abrasions or frost/freezer burns.
Never use the base, drawers, doors etc. to stand on or as supports.
Frozen food must not be refrozen once it has been thawed out.
Do not consume ice popsicles or ice cubes straight from the freezer as this can
cause freezer burn to the mouth and lips.
To avoid items falling and causing injury or damage to the appliance, do not
overload the door racks or put too much food in the crisper drawers.
WARNING - Food needs to be packed into bags before it is put into the
refrigerator. Liquids need to be stored in bottles or capped containers
in order to avoid a spill, as the design structure of the product is not
easy to clean.
This refrigerating appliance is not intended to be used as a built-in appliance.
This refrigerating appliance is not suitable for freezing foodstuffs.
CAUTION!
CARE AND CLEANING
Before maintenance, switch off the appliance and disconnect the mains plug
from the mains socket.
Do not clean the appliance with metal objects, steam cleaner, ethereal oils, organic
solvents or abrasive cleansers.
Do not use sharp objects to remove frost from the appliance. Use a plastic scraper.
INSTALLATION IMPORTANT!
For electrical connection carefully, follow the instructions given in this manual.
Unpack the appliance and check if there are damages on it. Do not connect the
appliance if it is damaged. Report possible damages immediately to the place you
bought it. In this case retain packing.
It is advisable to wait at least four hours before connecting the appliance to allow
the oil to flow back in the compressor.
Adequate air circulation should be around the appliance, lacking this leads to
overheating.To achieve sufficient ventilation, follow the instructions relevant to
installation. Wherever possible the back of the product should not be too close
to a wall to avoid touching or catching warm parts (compressor, condenser) to
prevent the risk of a fire, follow the instructions relevant to installation.
To Next Page
Loading...
