To Next Page

To Previous Page

4. You can turn the fan head oscillation on with the “SWING” button (5d). When the oscillation

is on, the “SW” indicator light (5i) is on. Press “SWING” (5d) again to turn oﬀ the oscillation.

5. Operate the “MODE” button (5e) to select the fan mode. The current fan mode is shown by its

indicator light (5h) being on. You can select from three fan modes:

- NOR: normal; the set fan speed is constant

- NAT: natural; the fan speed varies to simulate a natural air draught

- SLP: sleep; a silent fan mode with reduced and variable fan speed

6. You can set the time to automatically turn oﬀ the fan with the “TIMER” button (5c). The se-

lected oﬀ time is shown by its indicator light (5f) being on. The oﬀ time is adjustable from 0.5

to 7.5 hours in 0.5-hour increments. The oﬀ time shown by the indicator lights which are on

is aggregated.

7. To change the angle of the propeller, and thus the angle of the air stream, simply tilt the fan

head by holding the controls cover with the second hand to prevent the fan from overtur-

ning (ﬁg.1).

8. The head height can also be adjusted by loosening the head he-

ight adjustment nut (7), proper positioning of the head and tigh-

tening the nut.

9. If you want to turn oﬀ the fan, press the “OFF” button (5a) and

unplug the fan from the mains.

10. All of the above commands can be operated with the remote con-

trol (17) which features the buttons identical in function to the re-

spective buttons on the control panel (5).

CLEANING AND MAINTENANCE

WARNING! Do not immerse the appliance, its cord and plug in water or any other liquids

1. Before cleaning the appliance, unplug it from the power outlet.

2. The motor cover, controls cover, stand and cross of the fan, may be cleaned with a damp cloth

and a mild detergent, then wipe dry.

3. The mesh guards may be occasionally wiped with a brush to remove dust

from the holes. After the propeller is unmounted, wipe it with a damp cloth

with a detergent.

4. The remote control requires two 1.5 V AAA batteries to work. Access the

batteries by opening the battery compartment on the bottom side of the

remote control (Fig. 2). Mind the correct polarity and ﬁt when changing

the batteries. Do not mix diﬀerent types of batteries and/or spent batteries

with new batteries.

CAUTION! Do not dispose of spent batteries with household waste. Dispose of spent

batteries at designated battery collection points or return them to the seller. Never throw

batteries into ﬁre.

ﬁg.1

ﬁg.2

Questions and Answers:

Need help?

Do you have a question about the MPM MWP-19 and is the answer not in the manual?

MPM MWP-19 Specifications

General