Mpow MPBH070AB User Manual

-04- -05-
Specifications
Power on/off
Bluetooth Pairing
Bluetooth Version
Bluetooth Range
Battery Capacity
Working Time
Charge Voltage
Power on: Long press the multifunction button for
about 2 seconds, the red indicator light stays on for 1
second then blue indicator light starts flashing.
Power off: Long press the multifunction button for
about 3 seconds, the red indicator light stays on for 1
second then goes off.
1. Before using the receiver for the first time, you must
pair it with your smart device.
V3.0
up to 33 feet
300mAh
about 15 hours when
fully charged
DC 5.0V
2. Long press the multifunction button for about 5
seconds, it will enter pairing mode when the red and
blue indicator lights start flashing.
3. Turn on the Bluetooth function of your smart device.
4. Search for the Bluetooth devices and select "BT4807".
5. Enter the code "0000" if needed.
6. If paring is successful, the blue indicator light will
flash 2 times every 3 seconds.
7. Connect the device to your headset / Home Speakers
or Car Stereo System with 3.5mm audio cable.
8. Now you can enjoy music through your headset,
Home Speakers or Car Stereo System wirelessly.
Connect two Bluetooth devices
at the same time
1. Pair the Bluetooth receiver to the first smart device.
2. After pair successfully, turn off the Bluetooth function of
the first smart device.
3. It will enter pairing mode again.
4. Pair the Bluetooth receiver to the second smart device.
EN

Mpow MPBH070AB Specifications

General

Brand	Mpow
Model	MPBH070AB
Category	Receiver
Language	English