FCC STATEMENT
Operation is subject to the following three conditions:
1. This device may not cause harmful interference. and
2. This device must accept any interference received. including interference that may cause
undesired operation.
3. This device has been evaluated to meet general RF exposure requirement The device can be used
in portable exposure condition without restriction.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device.
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates. uses and can
radiate radio frequency energy and. if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception. which can be determined by turning the equipment off and on. the user is
encouraged to try to correct the interference by one or more of the following measures:
VOLUME +/-
Volume+: press and hold the MFB button of Right earbud to turn up the volume increasingly.
Volume-: press and hold the MFB button of Left earbud to turn down the volume decreasingly.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Support: https://www.xmpow.com/
To Next Page
Loading...
Need help?
General
