4
Customer Support
Maintenance
Operating Instructions
Troubleshooting
Safety Instructions
Assembly
WARNING!
Use of replacement parts or accessories from other manufacturer's will
invalidate the warranty and could damage the bed.
WARNING!
Plug the bed directly into a 110-120 VAC 60 Hz properly grounded Hospital
Grade outlet. Avoid use of extension cords at all times.
WARNING!
Do not operate the bed in the presence of flammable gases and oxygen.
WARNING!
The Electric Motors must remain dry. Care must be taken during cleaning
and use to ensure that electrical components remain dry.
WARNING!
Ensure that no damage is made to power cords by rolling the bed over them.
Ensure cords are not frayed or damaged.
WARNING!
When moving the bed place the handset Pendant control out of the reach
of the patient.
WARNING!
Fluid spills on the bed electronics can result in a hazard. In the event of a
spill, immediately:
•
Unplug the bed from the power source and remove it from service.
• Remove the patient from the bed and clean the spill
• Remove the bed from service until the bed is tested and determined to be safe.
Failure to do so may result in personal injury or property damage.
WARNING!
The siderails should always be in the up position when the patient is left
unattended. Test the siderails to ensure that they are properly latched before leaving the
patient..
WARNING!
Only authorized / certified personnel should perform preventative
maintenance. Maintenance by unauthorized personnel could result in property damage or injury.
WARNING!
Follow Manufacturer instructions when installing accessories especially
the Patient Helper Bar, this bar could fall and result in injury or death.
IMPORTANT SAFETY PRECAUTIONS - continued
WARNING!
Improper connection of the equipment grounding conductor can result
in the risk of electrocution. DO NOT modify the plug. The plug must be plugged into an
appropriate outlet that is properly installed and grounded. Check with a certified electrician.
To Next Page
