Spotlight Features:
Motion/Light Sensor: The light instantly turns on when it
detects motion from up to 30 feet away. The light sensor
conserves battery life by preventing the light from activating
in daylight.
Auto Shut-o: Light shuts o automatically after
20 seconds if no motion is detected.
Bright LED: 600 lumens cover up to 800 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant
material allow the light to work in all weather conditions.
Installation Instructions
High Performance Security Light
MB3100
• 4 D-cell alkaline batteries
• 1 screwdriver (Phillips)
• 1 screwdriver (athead)
• Drill (1/4” drill bit for drywall installation)
• 3 screws & 3 anchors
• Mounting bracket
LED Light
LED Light
Motion & Light
Sensor
NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.
What you need to install:
What is included per light:
www.mrbeams.com
Tips:
•
Use only new alkaline D-Cell batteries with 1.5V rating.
•
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
•
Install batteries with polarity in correct position.
•
Light may activate when batteries are inserted. Simply take light into a dark room,
allow batteries to settle, then test activation.
•
If your light will not turn o, it means that it is time to replace the batteries.
Battery Caution:
1) Do not mix old and new batteries
2) Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel cadmium) or
(nickel metal hydride) batteries
3) Do not dispose of batteries in re
4) Batteries should be recycled or disposed of as per state and local guidelines
3. Lift the battery lid o the back of the light. Insert 4 D-Cell
batteries with the at ends against the springs.
1. To remove the back plate from the light, use
your nger to push up on the mounting bracket
tab. This will unlock the bracket. Then slide the
bracket down o the back of the light.
7. Line up the light with the
mounting plate and slide the
light into the grooves.
4. Replace the battery lid and
make sure the screws are
twisted in tightly.
2. Use a screwdriver to loosen the four
screws on the back plate. The screws
will not come out all the way.
5. Before mounting your light, test the motion sensor
in a dark closet or bathroom. Close the light in the dark
room and leave for up to 5 minutes. When you re-enter
the room, the light should activate with motion.
6. Determine mounting location for the
light. Place the mounting plate on the
surface so that the tab is pointing down
and mark the pilot holes for drywall.
Use a drill to insert the anchors, then
line up the mounting plate with the
holes and drill screws in.
To Next Page
Need help?
General
