MRC MCX-5000 Series - 1.5 Function Settings

MARINE RADIO CO.,LTD.
주/선박무선
Subject : Auto Exchanger Page : (30 / 46)
Date : 2010.10.13 Doc. : MCX-5000S_ENG_R1
(QAS-ADD-008/1/10.10.13) manual\pabx\mcx-5000S\MCX-5000S_eng.doc
( MARINE RADIO CO., LTD.)
MRC
1.4 Type of Function
Initial programming
Function Description
1 Choose Dial Digit (2/3-Digit)
2 Extension Dial No. Edit
3 Trunk Input(Auto/Dial, Single/Group, ARS)
4 Trunk Input Delay Time Edit
5 Trunk Ringing Group Edit
6 Group Call Dial No. Edit
7 Priority
8 Usable
9 N/A
10 Find Malfunctioning
11 Reset Timer(N/A using NMEA)
12 Select Display UTC or LTC
13 Set New Password
14 Print out list for outgoing call.
1.5 Function of setting
1.5.1 Selection of dial digit
Set telephone dial number you wish to use.
(2-digit number or 3-digit number)
If press the "FUNC. KEY", password screen is displayed
(The default password is usually stored”1234” at the factory)
Screen is displayed as standby window.
Press the “01”
for Dial Digit edit mode.
The screen is changed to dial DIGIT input.
2 = two-digit extension numbers
3 = three-digit extension numbers
1.5.2 Dial Number Edit
This is a way to change the phone number.
The terminal extension number inside the telephone exchange has
its own unique address from 20 to 83(in case of MCX-5064 model only).
It cannot be changed.
At the input FUNCTION window, Press the 0, 2,
key, and then the
windows is changed to dial edit display.
PASSWORD
_
PASSWORD
1234_
FUNCTION
# _
FUNCTION
# 01_
DIAL DIGIT 2
DIGIT=_
FUNCTION
# 02_
ADR 00 D# 20
NEW D# _