MARINE RADIO CO.,LTD.
주/선박무선
Subject : Auto Exchanger Page : (31 / 46)
Date : 2010.10.13 Doc. : MCX-5000S_ENG_R1
(QAS-ADD-008/1/10.10.13) manual\pabx\mcx-5000S\MCX-5000S_eng.doc
(
MARINE RADIO CO., LTD.)
MRC
Previously stored information is displayed
Ex) 00(fixed address) : 20(Extension phone number)
If you want to change for extension number from 20 to 22.
In the right screen, press 22.
key.
If users want to change for extension number from 21 to 23.
In the right screen, press 23.
key.
In the case of another extension,
the users can be modified by using
key.
1.5.3 Trunk Input Mode
The users can set the desired phone from incoming calls from
outside by automatic or manual as follows.
And sequential or simultaneous forwarding can be determined from the outside call.
At the input FUNCTION window, Press the 0, 2,
key,
then the windows is changed to trunk input edit display.
Ex) 1= A(AUTO), 2=D(Extension Direct Dialing)
At the AUTO trunk window, Press the
key, then the window is
changed to call method edit mode.
Ex) 1= Single Call, 2=Group Call
If user press
key at the
trunk dial window, then ARS
selection window is displayed as
right figure.
Changed to call method edit mode.
But this feature is only available built-in voice recording chip on trunk card (Option).
If user press
key at the trunk dial or ARS selection window, then
next trunk configuration window is displayed as right figure.
1.5.4 Setup method of trunk call, delay time
The incoming calls from outside, operator can make time delay of the desired phone (Usually 10-20
seconds)
At the input FUNCTION window, Press the 0, 4
key, then the
windows is changed to delay time edit display.
ADR 00 D# 20
NEW D# 22_
ADR 01 D# 21
NEW D# 23_
ADR 02 D# 22
NEW D# 24_
FUNCTION
# 03_
TRK IN 1=A 2=D
CO1 =AUTO
TRK IN 1=A 2=D
CO1 =DIAL
TRK IN CALL 1=S 2=G
CO1 =GROUP
TRK IN CALL 1=S 2=G
CO1 =SINGLE
ARS 1=OFF 2= ON
CO1 =OFF
ARS 1=OFF 2= ON
CO1 = ON
TRK IN 1=A 2=D
CO2 = AUTO
FUNCTION
# 04_
To Next Page
Loading...