MRC MCX-5000B - System Failure Checking and Timer Reset; Process of Checking System Failures

MARINE RADIO CO.,LTD.
주/선박무선
Subject : Auto Exchanger Page : (34 / 46)
Date : 2010.10.13 Doc. : MCX-5000S_ENG_R1
(QAS-ADD-008/1/10.10.13) manual\pabx\mcx-5000S\MCX-5000S_eng.doc
( MARINE RADIO CO., LTD.)
MRC
Method of Calculation of numbers that each usable is given
Function No Method of Calculation (16)
TRUNK "15" usable 80
Ex : If usable : PAGING "01"
Priority call,
TRUNK "14",
TRUNK "15",
Please enter C9
total
1 + 8 + 40 + 80 = C9
(marked as 16)
TRUNK "14" usable 40
TRUNK "13" usable 20
TRUNK "12" usable 10
Priority Call 8
Group Call 4
Paging "02" “03 usable 2
Paging "01" usable 1
Expressed as
10 Decimal
0 1 2 3 456789101112 13 14 15
Expressed as
16 Hex
0 1 2 3 456789ABC D E F
1.5.9 Process of checking failure.
If problem from system occurs or handset is not put down properly,
The buzzer installed in Main Unit and is activated and Fault lamp is flashing simultaneously.
This is basically mode for checking information of it when fault occurs,
You can check information of fault without entering password.
If failure occurs, Press
key at initial screen.
If DC24V power is not supplied, that information will be displayed at LCD
Screen.
If several failures occur, you can check their information by pressing
key continuously.
For the other method for checking
failure, At screen for entering
number in "FUNCTION" mode, press 10 and,
for checking fault will be displayed.
* If there is no fault at all, text will be displayed like picture above.
Press
key to move next process, press key to exit process
1.5.10 Timer Reset
At screen for entering number in "FUNCTION“ mode
Press 1, 1, and
key, text for adjusting time will be displayed. (Current time: 2010.03.19 12:34:56)
Using the
button, the cursor is moved to desired
position and changed the actual time.
After you complete to adjust date & time and then press
key.
Modified time will be applied. Screen will be back to status for entering
number in "Function" Mode".
UT 2010 03 19
18:34:28
Failure Check
DC Power
Failure Check
TEL# 28
Failure Check
TEL# 21
Failure Check
Fail Not Found
TIME ADJ 2010
03-19 12:35:56
TIME ADJ 2011
09-19 10:30:03